| None buys a car now without a stereo in it but | | | | careful when he use the knife blades because a |
| some people face problem in removing an old | | | | small jerk may damage your stereo. By now |
| Kenwood stereo from their car. One might be | | | | would have got some idea about removal of it |
| very much interested to know How to remove a | | | | from your car. |
| Kenwood Stereo from the car. It is not a great | | | | The next common method other than using a |
| issue to remove a Kenwood stereo from the car | | | | knife blade is to use DIN tools. These tools are |
| provided you know the method to remove them. | | | | commonly used tools they are small and thin |
| There are three important things one need to do | | | | bladed moreover they have hooks in the end |
| before removing their Kenwood stereo first thing | | | | which will make the removing task easier than |
| is turning your car off. It is a usual thing all does | | | | usual. |
| before removing a stereo but its also one of the | | | | How do you use a DIN tool? It is very simple as |
| important thing in removing then parking brakes | | | | the previous method. One might have noticed slot |
| should be set and last thing is that to check | | | | openings on the radio. Using the DIN tools slide |
| battery and make sure that negative terminal of | | | | them on to that slots then push the DIN tools |
| the battery is removed so as to be safe from | | | | simultaneously and try to get a hold on the radio |
| short circuit when battery is removed. | | | | then one wont feel that hard to remove the |
| One can remove a Kenwood stereo with many | | | | Kenwood stereo from the car. Usually DIN tools |
| tools of their own but there are some tools | | | | are provided along with the radio that one buys |
| recommended to do the same which are knife | | | | .So he should have probably got it in case of not |
| blade, thin bladed tools which consists of hooks in | | | | having a DIN tool one can check out in any |
| it. The commonly used method is to remove the | | | | electronics store room. |
| stereo using small knife blades. One may wonder | | | | Finally should be very careful when one take the |
| how to remove using a knife blade? | | | | stereo out. He should remove them slowly and |
| First check out for a trim ring made out of plastic | | | | carefully. Now one can notice many wires there |
| which will be in any stereo. Before one use the | | | | on the back side of the stereo you need to |
| knife blades he should remove the trim rings then | | | | unplug them before taking the stereo out fully |
| slowly slide the knife blade available with him | | | | there are some coloured coded wires too which |
| underneath the corners of the stereo and try to | | | | one might to have removed. |
| pull it off carefully. One should be very much | | | | |